Skip to content Skip to sidebar Skip to footer

How To Install The Forepart Panel Usb


 Each duet of wires to the pins that volition live on linked to the publish How to install the front end panel usb


The steps are every bit follows:



  Each duet of wires to the pins that volition live on linked to the publish How to install the front end panel usb

Each duet of wires to the pins that volition live on linked to the number:
  • 1-3 to the HDD LED cable
  • 2-4 To the POWER LED cable 
  • 5-7 To RESET SW cable 
  • 6-8 To Cable POWER SW


 Each duet of wires to the pins that volition live on linked to the publish How to install the front end panel usb

 Each duet of wires to the pins that volition live on linked to the publish How to install the front end panel usb

 Each duet of wires to the pins that volition live on linked to the publish How to install the front end panel usb
Then pose each pin:
  • 2 [C] [D] [D +] [G] [] pairs of pins [VCC] [USB2-] [USB2 +] [GND] [empty]
  • 1 [C] [D] [D +] [G] tide pivot [VCC] [USB1-] [USB1 +] [GND]


 Each duet of wires to the pins that volition live on linked to the publish How to install the front end panel usb
  • In the outset event that is linked entirely MIC, MIC-POWER, AUD-OUT-R, AUD-OUT-L, in addition to GND.
  • In the minute instance in that place is the improver of which is connected at the outset event that in that place are two GND 
  • In the 3rd instance to a greater extent than connected but in that place is entirely i GND in addition to additions to the backout-R in addition to backout-L
Good Luck....